In the last section of the article acrylic processing technology - sculpture mentioned in acrylic processing technology - hanging gongs. Engraving is suitable for8mm thickness below acrylic processing, hanging gongs are suitable for more than 8mm acrylic sheet metal processing. In this article the source square will explain the acrylic processing hanging gongs this link.

Acrylic processing technology - hanging gongs are not just for the acrylic sheet above 8mm acrylic processing, but also can be large area large area excavation pattern groove of the unique characteristics of.

A large area of operation time, the source square remind must first use of large diameter bit hanging gongs, good control of hanging gongs acrylic size, later changed to a small diameter drill trim acrylic processing after the sheet edges, because acrylic processing technology - hanging gongs only through the high-speed rotation of the drill bit acrylic processing therefore, only finishing rounded, do right angle effect. So, if you do not select rectangular effect hanging gongs, but can choose CNC computer gongs.

Acrylic processing technology - hanging gongs used bit diameter are: 3mm,4mm,5mm,6mm,8mm,10mm,12mm,15mm bits in suspended gongs, if the request is greater in diameter, is the need to build the diameter of the drill bit for acrylic processing.

Acrylic processing technology - hanging gongs process in some matters needing attention, the source square here to make some of the details of the reminder: in the acrylic processing prior to step in if the coming out of small material irregular have errors, the acrylic hanging gongs out effect must have an error, but also the existence of acrylic sheet loss. In the acrylic processing hanging gongs large drill bit to drill when, need to adjust the height, as far as possible the same level, so you can avoid generating steps and obvious difference in threaded surface.